Comtech EF Data LPOD Specifikace stáhnout pdf (Strana 119)

LPOD C-, X-, or Ku-Band Outdoor Amplifier / Block Up Converter (BUC) MN-LPOD

Serial-based Remote Product Management Revision 10

5–19

Parameter Type

Command

(Instruction

Code and

Qualifier)

Arguments

for Command

or Response

to Query

Description of Arguments

(Note that all arguments are printable ASCII characters)

Response to

Command

(Target to

Controller)

Query

(Instruction

Code and

Qualifier)

Response to Query

(Target to

Controller)

Global Amplifier

Configuration

GAC=

43 bytes

Command or Query.

Sets or returns the global status of the BUC/SSPA with a semicolon delimited string in the form a;b;cc.cc;dd.dd;

e;fffff;g;hh;I;j;k;l;m;n;o where:

a = redundancy mode (ESW)

b = online status (ONL)

cc.cc = Attenuation Offset (AOF)

dd.dd = Customer Attenuation(ATT)

e = Auto Fault Recovery (AFR)

fffff = Unit Alarm Mask (MSK)

g = LNB Current Source (LCS)

hh = LNB Current Window (LCW)

i = LNB Current Window Enable (CWE)

j = Enable Statistics Averaging (ESA)

k = Set Statistics Interval (SSI)

l = Enable Statistics Logging (ESL)

m = Auxiliary Mute (AUX)

n = user mute state (MUT)

o = RF power amplifier state (AMP)

Example (set GAC): GAC=a;b;cc.cc;dd.dd;e;fffff;g;hh;I;j;k;l;m;n;o;’cr’

GAC=

GAC*

GAC?

GAC#

GAC?

GAC=x….x

(See Description of

Arguments)

Initialize Events

Pointer

IEP=

None

Command only.

Resets internal pointer to allow RNE? queries to start at the beginning of the stored events log.

Example: <1/IEP=’cr’

>0001/IEP=’cr’lf

IEP=

IEP?

IEP*

N/A

Software Image

IMG=

1 byte

Command or Query.

Sets or returns the current active software image in the form x, where:

1=Bulk Image # 1 currently active

2=Bulk Image # 2 currently active

Note: if you send the IMG command, and then query the IMG value the numbers may not be equal because the

command tells the firmware which image to boot from at the next bootup, and the query reports the image that the

firmware booted from on the last bootup.

Examples:

<1/IMG=1’cr’ (instructs the unit to load firmware from image #1 at the next reset / power up).

<1/IMG?’cr’ (queries the image number that the firmware loaded during bootup)

IMG=

IMG?

IMG*

IMG#

IMG?

IMG=x

(See Description of

Arguments)

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 217 218

Komentáře k této Příručce

Žádné komentáře

Comtech EF Data LPOD Specifikace Strana 119

Komentáře k této Příručce

Související produkty a manuály pro Audio zesilovače Comtech EF Data LPOD