Comtech EF Data SDM-650B Specifikace Strana 259

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 434
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 258
SDM-300L3 Satellite Modem Revision 0
System Checkout MN/SDM300L3.IOM
8–5
Figure 8-2. Typical Output Spectrum
8.1.3 Demodulator Checkout
Use the following procedure to test the demodulator.
1. Set up the equipment.
2. Set up the modem with an external IF loop and level. Use a properly operating
modulator, and ensure that power levels, data rates, code rates, etc., are
compatible.
3. Allow the modem to lock up. Depending on the data rate and overhead type,
lock up may take several seconds. When the green carrier detect LED is on and
the DEMUX lock fault has been cleared (where applicable), the modem will run
at the specified error rate. Run the TX power level (input amplitude) over the full
range, and offset the TX frequency from the RX frequency by 35 kHz. Ensure
the modem still runs within the specified error rate.
4. Set up the modem to check the constellation patterns with an oscilloscope that is
set in the X-Y mode. Typical constellation patterns with noise and without noise
are shown in Figure 8-4. These test points are available on the auxiliary
connector (J9, pins 6 and 8). It is not necessary to open the modem to look at
these test points.
Zobrazit stránku 258
1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 433 434

Komentáře k této Příručce

Žádné komentáře