Comtech EF Data Vipersat CDD-564L Specifikace Strana 41

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 172
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 40
2–1
Chapter 2. INSTALLATION
2.1 Unpacking
The CDD-56X Satellite Demodulator with IP Module and its Installation and Operation Manual are
packaged and shipped in a pre-formed, reusable cardboard carton containing foam spacing for
maximum shipping protection.
CAUTION
IMPORTANT
Do not use any cutting tool that extends more than 1” into the container and
cause damage to the unit.
Be sure to keep all shipping materials for the carrier's inspection.
Unpack and inspect the demodulator as follows:
Step Instructions
1
Inspect shipping containers for damage. If shipping containers are damaged,
keep them until the contents of the shipment have been carefully inspected and
checked for normal operation.
2
Remove the packing list from the outside of the shipping carton.
3
Open the carton by cutting the tape at the top of the carton (indicated by
OPEN
THIS END
).
4
Remove the cardboard/foam space covering the modem. Remove the modem,
manual and power cord from the carton.
5
Check the contents against the packing list to verify completeness of the
shipment.
6
Inspect the equipment for any possible damage incurred during shipment. If
damage is evident, contact the carrier and Comtech EF Data immediately and
submit a damage report.
7
Refer to the following sections for further installation instructions.
Zobrazit stránku 40
1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 171 172

Komentáře k této Příručce

Žádné komentáře